WeldConnect

AI steps

AI steps let a workflow write text or sort it into categories, for example draft a reply, summarise a ticket or decide whether a message is a complaint.

Find them under AI when you add a step.


AI Generate

Generates text from a prompt.

  1. Add an AI Generate step.
  2. Write the Prompt: the instruction for the model. Use variables to pass in data, for example Write a two-line welcome message for {{trigger.record.firstName}} from {{trigger.record.companyName}}.
  3. Optionally add a System Prompt (the role or tone the model should take), choose a Model (leave it blank for the recommended default), and set Temperature and Max Tokens.

Use the result in later steps as {{steps.<step>.text}}, for example as the body of a Send Email or Post Chat Message step.


AI Classify

Picks one category for a piece of text.

  1. Add an AI Classify step.
  2. Set Text to Classify, for example {{trigger.record.description}}.
  3. Under Categories, type each category and press Enter, for example complaint, question, praise.
  4. Optionally choose a Model.

The output has category, confidence and reasoning. Follow it with a Condition on {{steps.<step>.category}} to handle each category differently.


Credits

AI steps use your workspace's AI credits, the same balance other AI features in WeldSuite use. Each AI step's output includes creditsUsed, and the balance is under Settings → Billing.

When the workspace is out of credits, an AI step fails with a message about insufficient credits. The steps before it have already run.

Cap the credits per run

To keep a single run from using too many credits, set a cap:

  1. Open the workflow and go to the Settings tab.
  2. Under Quotas, enter Maximum credits used per run (a whole number between 1 and 100,000).
  3. Click Save.

Before every AI step, WeldConnect adds up the credits this run has already used and the most the next step could cost. If that would go over the cap, the step fails and says so; steps that ran before it are not undone. Leave the field empty for no limit.


Next steps

Previous
WeldSuite steps